Colour foam is a newly created solution that gives the vehicle wash a unique and distinctive appearance. On the car, a full foam coating in a variety of colors (red and blue) is applied using a water jet and the appropriate spray gun, or through the foam spray. Softened or osmotic water works nicely with foam. There are several benefits. This is not only cost-effective in terms of usage, time, and simplicity, but it also improves the wash station's image significantly. The visual effect is so spectacular that passing automobiles will almost certainly notice it. When Colour Foam comes into contact with the ground, it forms a thick, enveloping foam that rinses quickly and completely evaporates. A touchless vehicle wash's foam will be crimson.
Guide to using a colour foam
Step 1
Begin by parking your vehicle in a cool, shady location. This snow-coloured foam should not be used on the surface of a heated vehicle. Soap streaks will emerge on your vehicle if you don't have time to rinse coloured snow foam off before it hardens. After that, the car will be washed. Giving the region a gentle rinse with water is a good idea. This is particularly true if your car is unclean.
Step 2
The following stage, as previously stated, is to combine the foam with the right amount of water. Then it was used on a car with a foam lance. Connect the finished mixture to a plastic bottle. This procedure is the same whether you're using a pump stay or a pressurized washer. During the mixing process, you may notice that running water froths the automobile snow foam. Fill the bottle with the concentrate formulation and then use it to avoid this. In this approach, the concentrate will be slowly and evenly combined with water.
Step 3
Before you start adding foam, make sure your lance is calibrated for effective dispersion. This is true even if you have to use pump sprays. Adjust the amount and angle of the spray that will hit your car's surface in the proper manner. You can start applying foam after you've perfected this. If at all possible, spray from the top of your vehicle. Make sure the trunk, bonnet, and roof are all covered before moving on to the sides. Your car should have a light blue colour foam coating after the spraying process is completed. When applying automotive snow foam, pay special attention to the tires and wheels.
Step 4
Wait for the snow froth to evaporate before beginning to wash your car. While you wait, mix the snow foam with a soft towel or a soft-bristled brush. This is especially important for hard-to-reach areas like doorknobs, badges, and window sills.
Step 5
Once the colour foam has been dissolved, it will wash away from the automobile. It's an indication that the car foam needs to be rinsed. Using your pressure washer, remove all of the snow foam from your car. The area immediately beneath the bonnet window, as well as the mirrors, are prime targets. Snow foam also collects in wheel arches. While washing the foam with water, pay special attention to these regions.
Step 6
This is a step that is optional but will help you avoid wasting materials. If you're not a trained professional, you might not be able to get the desired results from a single wash. In most cases, the car wash chemical should still be in the lance. It's fine to go over the instructions again if any parts of your car aren't up to snuff.
AFoam Wash is a high-color-concentration pre-wash solution. Its purpose is to remove particles from the surface. Foam washing decreases the chance of scratching and swirling your car's paint when done correctly. The foam blue is intended to give the vehicle wash a unique and noticeable appearance. When it comes into contact with the ground, it forms a thick, enveloping foam layer that rinses quickly and dissipates.
If you're seeking further information, go to https://www.mafraindia.com/
or Dial +91-82-52-300-400
No comments:
Post a Comment